will do. and right now im running 7 fans. this case has room for push/pull rad at the top or front. the cam software will roconize two fan controllers so when its done i will have 3 120 front intake 3 120 side intake 1 120 rear exhaust and 6 120 push/pull top exhaust 13 fans in all and it will be a major fan under taking.
More fans = more air flow AND more noise or more fans at lower rpm can lead to the same air flow as fewer fans but now with less noise.
Fan controllers when setup correctly will allow you maximise airflow when required or balance noise and maintain good temperatures, but noise is not constant, there is a compound effect, 1 incredibly quiet fan makes less noise than 2 identically incredibly quiet fans operating together in the same conditions, however those 2 can be slowed down further to produce more combined air flow than the 1 on its own without a big impact on the noise levels.
That's where fan controllers can help, you can setup 'zones' such as:
- all the AIO fans in 1 zone, matching the push and pull speeds
- front intake as another zone
- rear exhaust, and bottom intake etc...
Finding the delicate balance for each zone will take a lot of time and work, as you will need to tune and balance each zone in isolation, testing, recording results and conditions, then repeating. If you get the balance wrong, you can end up with turbulence, which generates more noise and prevents effective cooling.
I am sure Jayz2cents and BitWit have videos but it's 1am and I am about to go to bed, so tired to look right now.
The important take away from this is that more fans are not always going to get you better cooling, if it's not done right, it can make your temperatures worse instead of better and add to the noise levels from your PC, a complete lose, lose situation instead of a win, win, so be careful and good luck. Or better still, test with the fans you have and only add more if your cooling is not good enough or if your current setup is too loud.